504150551 outside mirror compatible with IVECO EUROCARGO

504150551 outside mirror is a complete cab mirror assembly designed to fit IVECO Eurocargo platforms used in distribution and municipal service work, where stable rear visibility matters in tight streets and loading bays. For accurate ordering and stock control, this listing covers OE references 504150551, 504369979, 5801341206, 5801580261, 5801765363, 504150549S, and 504369977S.

The 504150551 outside mirror is built for daily fleet exposure to vibration, wind load, and repeated adjustment. A robust housing (commonly ABS/PP-based) and stable arm geometry help reduce mirror drift at speed, while a sealed joint concept helps protect the internal connector interface from moisture ingress during rain operation and pressure-wash routines.

Typical replacement triggers include cracked covers after depot impacts, loosened pivot points that cause blurred sight lines, or electrical issues such as intermittent adjustment due to worn plugs. During installation, technicians usually verify bracket alignment, fastener seating, and cable routing clearance to avoid harness strain and to keep adjustment response consistent.

Technicians often choose the 504150551 outside mirror when a direct-fit replacement is needed for mixed fleets, especially where the same mirror family is used across several cab configurations. Application listings commonly include designed to fit IVECO Eurocargo II (from 2003), designed to fit IVECO Eurocargo III (from 2008), and designed to fit IVECO Eurofire (from 1991). Fitment should be confirmed by OE reference and mounting configuration before ordering.

Packaging details for warehouse and transport planning:

For fleet procurement, keeping a single OE-controlled SKU list reduces picking errors and speeds depot replenishment. Use the OE references above on carton labels to simplify inbound receiving and cross-site transfers.

1. Secure the truck on level ground and follow workshop safety procedures.
2. Support the mirror assembly to prevent dropping and cab damage during removal.
3. Remove fasteners from the mirror arm/bracket interface and keep hardware organized.
4. If electrical functions are present, disconnect the plug carefully and inspect pins for corrosion or looseness.
5. Install the replacement, tighten fasteners evenly, and check bracket alignment.
6. Adjust the mirror, verify stable positioning under vibration, and confirm clear visibility before road use.

This product is intended for commercial vehicle service replacement with emphasis on mounting compatibility, stable positioning, and visibility performance under typical vibration and weather exposure. Always verify the OE reference and the mounting configuration on the vehicle before ordering and installation.

• Fit intent: consistent bracket interface and repeatable alignment.
• Use intent: supports long-haul routes, regional distribution, and depot yard maneuvering.
• Service intent: straightforward replacement workflow for workshop efficiency.

Compatible with Eurocargo II, Eurocargo III, Eurofire.